1. Place the ART Sparkling Water Maker on a flat sturdy surface in an upright position.

2. If a carbonating bottle is inside, remove the bottle. Never insert or replace the cylinder while a carbonating bottle is in the ART Sparkling Water Maker.

3. Remove the back cover by pulling it away from the body of the Sparkling Water Maker while placing one hand on top of the Sparkling Water Maker.

4. Raise the pink cylinder handle.

5. Remove the pink seal and cap from the Quick Connect Cylinder. Insert the cylinder into the cylinder holder by positioning the bottom of the cylinder into the Sparkling Water Maker and then gently placing the rest of the cylinder into the cylinder holder.

6. Lower the pink handle.

7. Replace the back cover by fitting the upright tab at the bottom into the rear slot at the base of the Sparkling Water Maker. Then push the cover into place onto the back of the Sparkling Water Maker.

If needed, use a mild liquid dish soap and a soft damp cloth to gently clean your ART Sparkling Water Maker. Wipe any spills to keep the base dry.

WARNING:

DO NOT use abrasive cleaners or sharp tools to clean.

DO NOT place your ART Sparkling Water Maker in water or wash in a dishwasher. Doing so will seriously damage your Sparkling Water Maker.

DO NOT place or store your Sparkling Water Maker close to a heat source.